供应Dataman48pro2

Dataman 448Pro2 Super Fast Gang ISP Production Programmer

Super fast universal gang programmer with four independent 48-pin ZIF sockets, ISP capabilities and USB 2.0 connectivity. Independent programming options combine with device insertion tests and a user friendly interface to give higher programming yields and reduced failure rates.

The 448Pro2 is built to meet the demands of high volume production programming with minimal operator effort.    



General:


>448Pro2 programmer offers the same advanced features as 448Pro+ programmer but with much higher programming speeds (20-70%) for high-capacity memories. 
>Independent programming is more efficient than the concurrent programming method used in traditional gang programmers as each site operates independently allowing programming to start as soon as each device is inserted into the ZIF socket. Before the last device is loaded, the first device is already programmed and ready for removal. The operator is always busy removing and inserting chips, so both the operator and programmer are running continuously at maximum efficiency. With traditional gang programmer operation, the operator is idle while chips are being programmed and the programmer is idle while chips are being removed and new chips inserted. Therefore for the medium programming times, you can easily achieve the throughput of an eight socket gang programmer with one 448Pro2 programmer. 
>FPGA based totally reconfigurable 48 powerful TTL pindrivers provide H/L/pull_up/pull_down and read capability for each pin of socket. Advanced pindrivers incorporate high-quality high-speed circuitry to deliver **s without overshoot or ground bounce for all supported devices. Pin drivers operate down to 1.8V so you''ll be ready to program the full range of today''s advanced low-voltage devices. 
>Each programming module performs device insertion tests and contact checks before it programs each device. These capabilities, supported by overcurrent protection and signature-byte check help prevent chip damage due to operator error. 
>The selftest capability allows diagnostics included in the software to thoroughly check the health of the programmer. 
>Built-in protection circuits eliminate damage of the programming module and/or programmed device due to environment or operator failure. All ZIF socket pin inputs of the Dataman 448Pro2 programmer are protected against ESD up to 15kV. 
>Dataman 448Pro2 programmer performs programming verification at the marginal level of supply voltage, improving yield and guarantees long data retention. 
>Various socket converters are available to handle device in PLCC, SOIC, PSOP, SSOP, TSOP, TSSOP, TQFP, QFN (MLF), SDIP, BGA and other packages.

Programmer Specification:


>4 x universal programming modules (4 x 48-pin DIL ZIF sockets and 4 x ISP connectors) 
>Operation result LEDs, LED power 
>USB 2.0 high-speed compatible port 
>Protection against surge and ESD on power supply input 
>Banana jack for ESD wrist strap connection 
>Banana jack for connection to ground

Module Specification:

Base Unit (DAC)


>On-board intelligence: powerful microprocessor and FPGA based state machine 
>Three D/A converters for VCCP, VPP1, and VPP2, controllable rise and fall time 
>VCCP range 0..8V/1A 
>VPP1, VPP2 range 0..26V/1A 
>Selftest capability

ZIF Socket:


>48-pin DIL ZIF socket accepts both 300/600 mil devices up to 48-pin 
>Pindrivers: 48 universal 
>VCCP/VPP1/VPP2 can be connected to each pin 
>Perfect ground for each pin 
>FPGA based TTL driver provides H, L, CLK, pull-up, pull-down on all pindriver pins 
>Analog pindriver output level selectable from 1.8V up to 26V 
>Current limitation, overcurrent shutdown, power failure shutdown 
>ESD protection on each pin of socket (IEC1000-4-2: 15kV air, 8kV contact) 
>Continuity test: each pin is tested before every programming operation

ISP Connector:


>20-pin male type with missinsertion lock 
>6 TTL pindrivers, provides H, L, CLK, pull-up, pull-down; level H selectable from 1.8V up to 5V to handle all (including low-voltage) devices 
>1x VCCP voltage (range 2V..7V/100mA), can be applied to two pins 
>Programmed chip voltage (VCCP) with both source/sink capability and voltage sense 
>1x VPP voltage (range 2V..25V/50mA), can be applied to six pins 
>Target system supply voltage (range 2V..6V/250mA) 
>ESD protection on each pin of ISP connector (IEC1000-4-2: 15kV air, 8kV contact) 
>Two output **s, which indicate state of work result = LED OK and LED Error (active level: min 1.8V) 
>Input **, switch YES! equivalent (active level: max. 0.8V)

公司专营国内外多种量产型、研发型、**型编程器、大型全自动芯片编程器、IC编带机及附属烧录插座、模组等全套烧录设备及器材；芯片测试所使用的SOIC, PLCC, SOT,SOJ,TSOP, SSOP,TQFP, PQFP,QFN, MLF, BGA等封装的转接座、烧录座。高精密IC老化测试插座、高频测试座、适配座等器材设备以及电子产品类开发、生产电子设备工具及配件材料的销售。可代设计定做**、冷偏门烧录座、IC测试座；编程器等设备维修；IC来料烧录加工；单片机解密。

产品销售：
* 国内外各**编程器适配座\Adapter、烧录座、烧录模组：SOIC，SOP，SOT，SOJ，PLCC，PSOP，TSOP，TSSOP，TQFP，PQFP，DFN，QFN, MLF, BGA等；代客户定做冷偏门烧录座及**IC适配座。
* 上万种不同**常用规格SOCKET**制品（包括客制品和已停产产品），帮客户解决非标准IC的定制服务。
* 近20种**150多种型号研发型、产量型、通用型、全自动等编程器\烧录器：
研发型：
BP       ：1610，1710
崇贸     ：T9600，T9800，T7000，
Minato  ：M1881UXP，M1940，M1950，M1894，M1896
Dataman  ：Dataman MEMPro，Dataman PIKPro，Dataman 40Pro，Dataman 48Pro2，Dataman 48Pro+
DATA  IO：Plus 48
Dediprog  ：EM100，SF100，SF-200，SF300
Eetools   ：ChipMax，ChipMaxII，Top-MaxⅡ
ELNEC  ：SmartProg2，PRO-48，Beeprog，BeeProg+，Beeprog2
Hilo     ：ALL-11A，All-100
Leap     ：LEAPER-3C，LEAPER-3D，LEAPER-5E，LEAPER-48，LEAP-PSTART，SU600
Xeltek    ：280U，580U，3000U，500P，501S，5000，5000E
WELLON：VP280，VP380，VP490，VP690，VP890
研仪    ：LabTool-48，LabTool-48UXP
TOP    ：TOP853，TOP2007，TOP2009，TOP2049，TOP3000，TOP3100
ZLG    ：SmartPRO 5000U，SmartPRO T9000，SmartPRO X8，SmartPRO X5，EasyPRO 80B
RF      : RF1800，RF910，RF3148
量产型：
BP      ：2610，2710，2800F，4710，4610，3000FS，3610，3710MK2，Helix-TR，Helix-TU，HelixFS-TR，HelixFS-TU
崇贸    ：AP520，AP600，AP700，AP800
Minato：AH-783，AH-784
Data Io  ：FlashPAKIII，PS288，PS388，PS588 。。
dataman ：Dataman 448Pro2，Dataman 448Pro+，Dataman 848Pro2
ELNEC ：Beehive4，BeeHive4+，BeeHive204，BeeHive8S，BeeHive208S 
Eetools：FlashMax，MultiMax 8G+，ProMax，SpeedMax
Hilo    ：ALL-100GANG，ALL-100G4，AT3-300，AT3-300A，AT3-300AL
Leap    ：SU-300，su1000，su2000，su3000，su6000，AH-1000   
Xeltek  ：9000U，5004，5004EGP
研仪   ：LabTool-848XP，LabTool-T400
服务电话（TEL）：400-856-9596